• open panel

1-wire devices


Above is the 1-wire devices’ settings. It is possible to name the devices, delete devices, as well as scanning the buses(A/B) for new devices. As default number 1 and 2 are scanned for temperature sensors if no devices have been saved. Note! The actual maximum numbers of simultaneously connected devices per bus depends on wire lengths, power supply, cabling, etc, so it may be lower than 25. 

Version 4.0 adds two new types of 1-wire-devices:

Version 4.23:

Those two types share the same identification code so they need to be scanned one at a time in order to select the correct type:


Version 4.5 adds a column showing the status of the device.

Version 4.68:

Version 4.72


© 2011-2023 Microbit 2.0 AB

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.